
Why Does a Plastic Shredder Jam? Common Causes and What to Check
Jams are rarely random. Most trace back to how the shredder is fed, the condition of its cutting tools, or a mismatch between the material
Our Online Store Is Now Available For Ordering.
The Right Machine for Today’s Recycling Requirements

Jams are rarely random. Most trace back to how the shredder is fed, the condition of its cutting tools, or a mismatch between the material

Walk through almost any compounding or extrusion plant and you’ll find it: a gaylord, a corner, sometimes a whole bay full of hardened purge. Hockey-puck

Most molders don’t think of themselves as recyclers. But every shot from a cold-runner tool produces plastic you paid for and can’t sell, and every

Every extrusion line makes scrap. Startup lengths come off before the line settles. A die change leaves a run that misses tolerance. A coil gets

Both designs reduce bulky material. They do it in different ways, produce different output, and fit different places in a recycling line. “Single shaft or

The rotor is the heart of a shredder. Its diameter, speed, width and knife design decide what the machine can handle and what comes out

A new shredder or granulator is easiest to ruin in its first few hours: skipped guarding checks, a rushed first feed, a break-in nobody did.

Cutting plastic turns mechanical work into heat, and heat softens flake, degrades polymer, and stresses machines. It rarely gets discussed until regrind starts clumping. Here

A rated throughput number is an answer to a question about ideal material. Feed the machine something bulkier, harder, or finer, and the real number

A tramp bolt, a handful of grit, a stream of fines. None of it shows up on the purchase order, but all of it shows

Two piles of the same plastic can be worth very different amounts. The difference is not the polymer. It is how clean, consistent, dry, and

The screen is a perforated steel half-cylinder that costs a fraction of the machine around it. It may also be the single spec that most